A Raspberry Pi with a camera, gives you a small, low cost, embedded vision system, but it’s not very mobile. In this tutorial we show you how to fix that by attaching it to a robot to give you a Raspberry Pi camera robot! The robot is WiFi enabled which means you can drive it around using a tablet, phone or computer, using the camera to explore remote areas.

We’ve tried to keep the components for this tutorial as affordable as possible, and as such we’re using the Dagu Arduino Mini Driver to control the motors and servos of the robot. This board also contains a 1A voltage regulator which we can use to power the Pi. Now a limit of 1A is a bit tight for the Pi, but we’ve found that with the right WiFi dongle, the Mini Driver voltage regulator can happily power itself, the Pi, a camera, and WiFi. All the ingredients you need for a camera robot.

Update: This robot also works with the new Model B+ Pi. We’ve updated the instructions to reflect this below.

Update: We’ve now changed the robot slightly so that it uses a UBEC to power the Pi. This extends the battery life of the robot, and increases the current limit for the Pi to 3A.

Continue reading →

Update: This post is now out of date as we’ve released a new version of the software. You can find an updated version of the instructions here.

This post describes all the steps we go through to set up a Dawn Robotics SD Card. This SD card contains Raspbian with software installed on it to support a Raspberry Pi robot, and also to support the Pi Co-op Arduino add-on board we sell. If you want to get up and running quickly, then you can just download a complete version of the SD card image here, or alternatively buy a pre-installed SD card from us here. For people who want to build their SD card image from scratch however, or who want to customise it for their own Raspberry Pi robot, hopefully this set of notes will be a good guide to show you what we’ve done.

Continue reading →

Happy New Year everyone! Things have been a bit quiet on this blog due to the Christmas rush, and the fact that we’ve been spending time on product development (more on that in a future post). But here at last is the 3rd and final post in our series on the Raspberry Pi robot we used for a workshop at the now not so recent Digimakers event at @Bristol.

In part 1 we described the hardware of the robot, in part 2 we talked about the software that ran on the robot. In this post we’ll talk about about the the Scratch simulator which the workshop participants used to create their robot control programs, and our experience of running the workshop. Continue reading →